Skip to content
English
  • There are no suggestions because the search field is empty.

How do I connect my launch monitor to my network?

The only launch monitor that can be connected through your network (Wi-Fi or hard-wired to router) is the EYE MINI launch monitor; all other launch monitors are designed explicitly to connect to Uneekor software through the PC (via Ethernet).

EYE MINI - Hardwired Network Setup

To set up the EYE MINI for use with your PC through a router, network switch, or wall jack connection, please follow these steps:

  1. Navigate to the Settings menu (top-right) within Uneekor Launcher
  2. Enter the Devices menu, then click Add a new device
  3. Select EYE MINI from the list, then click Continue
  4. Move the EYE MINI to the location specified on-screen, then click It's in place
  5. Select the Network option, then click Continue
  6. Follow the on-screen instructions to proceed with EYE MINI setup


If the EYE MINI shows up as a connected launch monitor after following all of the above steps, then congratulations, your EYE MINI is now configured for use on your PC! You can now install the licensed software from the main menu of Uneekor Launcher. Test out some shots in VIEW to make sure it's working as expected.

EYE MINI - Hardwired Direct Setup

To set up the EYE MINI for use with your PC, please follow these steps:

    1. Navigate to the Settings menu (top-right) within Uneekor Launcher
    2. Enter the Devices menu, then click Add a new device
    3. Select EYE MINI from the list, then click Continue
    4. Move the EYE MINI to the location specified on-screen, then click It's in place
    5. Select the Direct option, then click Continue
    6. Follow the on-screen instructions to proceed with EYE MINI setup


If the EYE MINI shows up as a connected launch monitor after following all of the above steps, then congratulations, your EYE MINI is now configured for use on your PC! You can now install the licensed software from the main menu of Uneekor Launcher. Test out some shots in VIEW to make sure it's working as expected.

EYE MINI - Wi-Fi Network Setup

Ensure that the EYE MINI is connected to the same Wi-Fi network as the PC that you want to connect to by following these steps:

    1. Connect the EYE MINI to either your PC, or your router / wall jack / network switch via Ethernet cable
    2. Navigate to the EYE MINI's onboard Settings
    3. Go to page 3, then set Ethernet to Static if connected directly to PC, otherwise set to Dynamic
    4. Set Wi-Fi to Station(Client) — the AP(Access Point) mode is for iPad only
    5. Press BACK on the EYE MINI to save your changes
    6. Navigate to the Settings menu (top-right) within Uneekor Launcher on your sim PC
    7. Enter the Devices menu, then select your EYE MINI
    8. Under Wi-Fi Settings, connect to the Wi-Fi network that the PC is connected to


Once configured, your EYE MINI will have the option to connect to the internet over Wi-Fi, as opposed to doing so through Ethernet. If you have completed the above steps and would like to use the EYE MINI wirelessly, then follow these steps:

    1. Disconnect the Ethernet cable from the EYE MINI
    2. Click Refresh in the top-right (of Uneekor Launcher's Settings > Devices > EYE MINI page) to check if it is properly connected over Wi-Fi