Skip to content
English
  • There are no suggestions because the search field is empty.

How do I reset my launch monitor?

To reset your Uneekor launch monitor, power cycle it by following the instructions below.

EYE MINI

  1. Hold the power button down for 5+ seconds, until the screen turns off.
    1. Note that there will be no change to the status of the E Ink screen if the battery is drained, in which case you should charge it for 30+ minutes before attempting this
  2. Wait 5+ seconds, then firmly press the power button to power it back on.

Other launch monitors

  1. Power down the launch monitor by flicking off its power switch on the launch monitor, or by disconnecting its power source.
  2. Wait 45+ seconds for the electricity to fully discharge, then power the launch monitor back on by flicking on its power switch, or by reconnecting its power source.