UNEEKOR LAUNCHER INSTALLATION GUIDE
Minimum PC Requirements
• Intel i5 8400
• 8 GB RAM (16 GB RAM for Swing Optix)
• GeForce GTX 1060**
• Windows 10 (64 bit) Version 1803 or higher***
• Integrated ethernet port required
• PC Sold Separately
• * Uneekor Launcher requires a consistent internet connection to function
• ** AMD: 3rd gen Ryzen or higher and AMD Ryzen 3600X or higher (AMD 2700 is not
compatible)
• *** Not compatible with MacOS
• Internet connection required*
Please follow these instructions to install the Uneekor Launcher.
- Create a MyUneekor account
- From our website's Resources page download the Uneekor Launcher
- For help with installation, please refer to the Uneekor Launcher Installation Guide.
Please take your time exploring what can be done with the Uneekor Launcher and let us know if you have any questions.
Note that for QED users, the IGNITE software has been retired and is no longer supported by Uneekor; it has been replaced with the VIEW software.
If you had an older version of our software installed before the Uneekor Launcher, then please make sure to uninstall the old software.
To uninstall the Legacy versions of Uneekor software, please follow the steps below:
1) Open File Explorer, navigate to your C: drive, and delete the following folders if available:
- Z3CAMSensor
- EYEXOSensor
- QED_IGNITE
- VIEW
- QED_REFINE
- REFINE
- QED_SUCCEED
- REFINE+
You should leave the "Uneekor" folder alone, as this is where the Uneekor Launcher and newer versions of Uneekor software are installed.
2) Go to your desktop, and delete the following shortcuts if available:
- Z3CAM_TOOL
- EYEXO_TOOL
- QED_IGNITE
- QED_IGNITE_SO
- VIEW (leave Uneekor VIEW alone)
- Pod
- QED_REFINE
- REFINE (leave Uneekor REFINE alone if available)
- QED_SUCCEED
- REFINE+ (leave Uneekor REFINE+ alone if available)